Drive Shaft Assembly

Drive Shaft Assembly Parts Required

PART NUMBER

DESCRIPTION

QTY.

REV-41-1324

3MM SPACER

4

REV-41-1326

THROUGH BORE BEARING - SHORT

3

REV-41-1327

SHAFT COLLAR

2

REV-41-1338

10 TOOTH #25 SPROCKET

1

REV-41-1348

5MM X 90MM HEX SHAFT

1

REV-41-1190

90MM OMNI WHEEL

1

Drive Shaft Asssembly Steps

DRIVE SHAFT ASSEMBLY STEPS

Add a Shaft Collar flush to the end of the 5mm x 90mm Hex Shaft.

Tighten the Shaft Collar.

Slide a 90mm Omni Wheel onto the shaft.

Slide a Through Bore Bearing – Short onto the shaft.

Note the smaller portion of the bearing faces towards the Shaft Collar.

Slide a Through Bore Bearing – Short onto the shaft.

Note the smaller portion of the bearing faces towards the Shaft Collar.

Slide a 3mm Spacer onto the shaft.

Slide a 10 Tooth # 25 Sprocket onto the shaft.

Slide a Shaft Collar onto the shaft. Keep this Shaft Collar loose.

Slide a 3mm Spacer onto the shaft.

Slide a 3mm Spacer onto the shaft.

Slide a 3mm Spacer onto the shaft.

Slide a Through Bore Bearing – Short onto the shaft.

Note the smaller portion of the bearing faces away from the Shaft Collars.

DRIVE SHAFT ASSEMBLY COMPLETE

Repeat the above steps until there are two completed Drive Shaft Assemblies. Set aside for later.