PART NUMBER
DESCRIPTION
QTY.
3MM SPACER
2
THROUGH BORE BEARING - SHORT
2
SHAFT COLLAR
1
10 TOOTH #25 SPROCKET
2
5MM X 90MM HEX SHAFT
1
Add a Shaft Collar flush to the end of the 5mm x 90mm Hex Shaft.
Tighten the Shaft Collar.
Slide a Through Bore Bearing – Short onto the shaft.
Note the smaller portion of the bearing faces towards the Shaft Collar.
Slide a 3mm Spacer onto the shaft.
Slide a 10 Tooth # 25 Sprocket onto the shaft.
Slide a 10 Tooth # 25 Sprocket onto the shaft.
Slide a 3mm Spacer onto the shaft.
Slide a Through Bore Bearing – Short onto the shaft.
Note the smaller portion of the bearing faces away from the Shaft Collar.
DOUBLE SPROCKET ASSEMBLY COMPLETE
Repeat the above steps until there are two completed Double Sprocket Assemblies. Set them aside for later.
