4
THROUGH BORE BEARING - SHORT
3
SHAFT COLLAR
2
10 TOOTH #25 SPROCKET
1
5MM X 90MM HEX SHAFT
1
90MM OMNI WHEEL
1
DRIVE SHAFT ASSEMBLY STEPS
Add a Shaft Collar flush to the end of the 5mm x 90mm Hex Shaft.
Tighten the Shaft Collar.
Slide a 90mm Omni Wheel onto the shaft.
Slide a Through Bore Bearing – Short onto the shaft.
Note the smaller portion of the bearing faces towards the Shaft Collar.
Slide a Through Bore Bearing – Short onto the shaft.
Note the smaller portion of the bearing faces towards the Shaft Collar.
Slide a 3mm Spacer onto the shaft.
Slide a 10 Tooth # 25 Sprocket onto the shaft.
Slide a Shaft Collar onto the shaft. Keep this Shaft Collar loose.
Slide a 3mm Spacer onto the shaft.
Slide a 3mm Spacer onto the shaft.
Slide a 3mm Spacer onto the shaft.
Slide a Through Bore Bearing – Short onto the shaft.
Note the smaller portion of the bearing faces away from the Shaft Collars.
DRIVE SHAFT ASSEMBLY COMPLETE
Repeat the above steps until there are two completed Drive Shaft Assemblies. Set aside for later.
