PART NUMBER
DESCRIPTION
QTY.
15MM SPACER
1
3MM SPACER
2
THROUGH BORE BEARING - SHORT
2
SHAFT COLLAR
1
10 TOOTH #25 SPROCKET*
1
5MM X 90MM HEX SHAFT
1
Add a Shaft Collar flush to the end of the 5mm x 90mm Hex Shaft.
Tighten the Shaft Collar.
Slide a Through Bore Bearing – Short onto the shaft.
Note: the smaller portion of the bearing faces towards the Shaft Collar.
Slide a 3mm Spacer onto the shaft.
Slide a 10 Tooth # 25 Sprocket onto the shaft.
Note: For the Mecanum Drivetrain Kit, replace the sprocket with a 24 Tooth Pulley
Slide a 15mm Spacer onto the shaft.
Slide a 3mm Spacer onto the shaft.
Slide a Through Bore Bearing – Short onto the shaft.
Note: the smaller portion of the bearing faces away from the Shaft Collar.
SINGLE SPROCKET ASSEMBLY COMPLETE
Repeat the above steps until there are two completed Single Sprocket Assemblies. Set aside for later.
