PART NUMBER
DESCRIPTION
QTY.
90MM OMNI WHEEL
1
END CAP BEARING
2
3MM SPACER
2
90 TOOTH PLASTIC GEAR
1
5MM X 75MM HEX SHAFT
1
Add an End Cap Bearing to the 75mm x 5mm Hex Shaft.
Slide a 3mm Spacer onto the shaft.
Slide a 3mm Spacer onto the shaft.
Slide a 90mm Omni Wheel onto the shaft.
Slide an 90 Tooth Plastic Gear onto the shaft.
Add an End Cap Bearing to the shaft.
Note: the smaller portion of the bearing faces away from the gear
OMNI WHEEL ASSEMBLY COMPLETE.
Repeat the above steps until there are two completed Omni Wheel Assemblies. Set aside for later.
