PART NUMBER
DESCRIPTION
QTY.
90MM GRIP WHEEL
1
END CAP BEARING
1
15MM SPACER
1
3MM SPACER
2
SHAFT COLLAR
1
THROUGH BORE BEARING - LONG
1
90 TOOTH PLASTIC GEAR
1
5MM X 135 MM HEX SHAFT
1
Add an End Cap Bearing to the 135 mm x 5mm Hex Shaft.
Slide a 3mm Spacer onto the shaft.
Slide a 90mm Grip Wheel onto the shaft.
Slide a 90 Tooth Plastic Gear onto the shaft.
Slide a 15mm Spacer onto the shaft.
Slide a 3mm Spacer onto the shaft.
Slide a Shaft Collar onto the shaft. Make sure the shaft collar is flush with the 3mm Spacer. Tighten the set screw.
Slide a Through Bore Bearing - Long onto the Shaft.
Note: the longer portion of the bearing faces away from the Shaft Collar.
MIDDLE GRIP WHEEL ASSEMBLY COMPLETE
Repeat the above steps until there are two completed Middle Grip Wheel Assemblies. Set aside for later.
