System Standards

REV ION was created to minimize the required tools, hardware, and cost to build a robot. To accomplish this the REV ION System has standardized the following throughout its products:

#10 Clearance Holes

• All hardware is #10-32 sized

• Any tapped holes are #10-32

• Can use 3/16in rivets

• Linear pattern or grid on structural components

• Radial pattern on circular components

• Some circular components also have the linear pattern for ease of attaching to structure

• 13.75mm diameter rounded corners for ease of assembly in bearings

• Fits standard 1.125in OD Bearings

• Components together along a shaft always have a total width on a fractional interval