The additional spur gears (21T(22) and 20T(22)), alongside the base spur gear (REV-21-3005-P11) included in the MAXSwerve Module Kit, allow for three distinct wheel speed options.
When using a Kraken X60 with the MAXSwerve, the spur gear will be replaced to adjust speeds instead of the pinion.
During assembly, the spur gear of choice will be added during step 3 of the
In order to utilize the Kraken X60 motor you will need to file approximately 1mm of material off the MAXSwerve Top Plate (to make clearance for the bump out present in the motor) at the corners of the motor mounting pocket.
Which corner must be filed will depend on the chosen orientation of the motor.
Add the Kraken Spacer to the top of the motor before adding the top plate. This will help to accommodate differences in shaft length between the Kraken and other MAXSwerve compatible motors.
The Pinion Spacer slides over the shaft to provide proper spacing and compatibility with the Encoder Bridge (REV-21-3005-P26).
This step is the same as when using a NEO motor to assemble the(Step 4).
During , the default drive motor pinion in the kit will be replaced with the Drive Motor Pinion - 15T Spline Bore - 14T. The pinion boss should be facing away from the motor.
