MAXSpline Grommet

The MAXSpline Grommet provides a simple way to route wires through MAXTube while preventing abrasion against bare aluminum. Made from pliable 60A rubber, it press-fits into the MAXSpline Bore on MAXTube with a 1/8 inch wall, creating a clean pass-through point that protects your wiring in any build.

Tips and Tricks

MAX Pattern Tubing makes wire management simple, but the sharp edges from the pattern holes can tear up your CAN/PWM cable's sheathing. MAX Grommets are easy to install and allow smooth pass-through.

Grab your grommet and line the spline teeth into the grooves. Start working the lip of the grommet around the teeth so that it covers the gaps.

Double-check that both lips of the MAX Grommet are covering all sharp edges from the pattern hole. Now you can safely move your wires without worry.