Power Distribution Hub Specifications

We're Updating our Documentation! For the most up-to-date information about the Power Distribution Hub and other ION Control System Devices please check out the following new documentation pages:

The following tables provide the operating and mechanical specifications for the Power Distribution Hub (PDH).

DO NOT exceed the maximum electrical specifications. Doing so will cause permanent damage to the Power Distribution Hub and will void the warranty.

The Power Distribution Hub's reverse polarity protection DOES NOT protect downstream devices. Verify the correct polarity on all power wires before operation.

Main Electrical Specifications

Make sure to take into consideration current requirements when choosing wire gauge for any given application.

High Current Channel Specifications

Low Current Channel Specifications

It is recommended to use a 20A fuse for a single Pneumatic Hub or Pneumatic Control Module connected to any of the three Low-current Channels if using a compressor with higher peak current draw, such as the CP26 or the Thomas 405ADC38.

Switched Channel Specifications

Mechanical Specifications

DO NOT use thread-locking fluid on the mounting hardware for the REV Power Distribution Hub. Thread-locking fluid will damage the ABS plastic case.

Mechanical Drawings

Last updated