Getting Started with Control Hub

After receiving the Control Hub it is advised to unbox the device, power the Control Hub on, and start the configuration process. Below are the required materials to run through the initial bring up of the Control Hub and links to the different steps of the process. 
Section 
Summary
​Connect to the Robot Controller Console​
In order to manage the Control Hub (REV-31-1595) or programming using the onboard programming languages you must have access to the Robot Controller Console. Follow through the steps in this section to ensure your Control Hub is connecting properly 
​Updating Wi-Fi Settings​
Once in the Robot Controller Console, update your Control Hub's Wi-Fi settings for better performance and network security.
​Connecting Driver Station to Control Hub 
A Driver Station is required to in the REV Control System, to run code remotely. This section walks through the steps of connecting a Driver Station device to a Control Hub. 
​Wiring Diagram​
Showcases what hardware components plug into which ports on the Control Hub. 
​Next Steps​
Once the hardware components are connected to the Control Hub, the basic steps for getting started have been covered. This section covers the important next steps you should take for working with and maintaining your Control System.
Required Materials
Control Hub (REV-31-1595)
12v Slim Battery (REV-31-1302)
Driver Hub (REV-31-1596)
USB Game Pad (REV-39-1647)
USB A Female to Micro USB (REV-31-1426)
Windows PC running the REV Hardware Client​
Optional Additional Materials needed to Connect an Expansion Hub:
Expansion Hub (REV-31-1153)
XT30 Extension Cable (REV-31-1392, included with Expansion Hub)
JST PH 3-pin Communication Cable (REV-31-1417, included with Expansion Hub)
Videos
Using a Web Browser
Using the REV Hardware Client
​

Introduction

Connect to the Robot Controller Console

Last modified 6mo ago

Export as PDF

Copy link

Contents

Required Materials

Videos