The Control Hub powers off a single 12V Slim Battery. Using an approved battery is the ONLY way the Control Hub should be powered. It cannot be powered directly from a charger or via USB.
Switch Cable
Adding a switch cable is recommended to allow the Control Hub to be easily powered on and off without removing the battery.
Motor Wires
JST VH 2-pin Motor Cable
These cables are used to provide power to the motors connected to the Control Hub.
JST PH 4-pin Sensor Cables
Used with the motors in the EDU Kit V2 to send information from the encoders to the Control Hub.
PWM Cable
PWM, or pulse-width modulation, is a signal type used to communicate with different devices, such as the servos found in the EDU Kit V2.
