The following tables provide the operating and mechanical specifications for the SPARK Flex Motor Controller.
DO NOT exceed the maximum electrical specifications. Doing so will cause permanent damage to the SPARK Flex and will void the warranty.
| Parameter | Min | Typ | Max | Units |
|---|---|---|---|---|
| Parameter | Min | Typ | Max | Units |
|---|---|---|---|---|
| Parameter | Min | Typ | Max | Units |
|---|---|---|---|---|
| Parameter | Value and Units |
|---|---|
Input Voltage (Nominal)
-
12
-
V
Operating Voltage Range †
6
-
24
V
Absolute Maximum Supply Voltage
-
-
30
V
Continuous Output Current ††
-
-
60
A
Peak Current (2 second surge)
-
-
100A
A
†
6 V minimum for 5 V Data Port output. 4.5 V minimum before full brownout.
††
Continuous current duration tested at 3 minutes.
Full-reverse Input Pulse
-
1000
-
μs
Neutral Input Pulse †
-
1500
-
μs
Full-forward Input Pulse
-
2000
-
μs
Valid Input Pulse Range
500
-
2500
μs
Input Frequency
50
-
200
Hz
Input Timeout ††
-
50
-
ms
Default Input Deadband †††
-
5
-
Hz
Input High Level
0.5
0.7
0.9
V
†
Neutral corresponds to zero output voltage (0 V) and is either braking or coasting depending on the current idle behavior mode.
††
If a valid pulse isn't received within the timeout period, the SPARK Flex will disable its output.
†††
Input deadband is added to each side of the neutral pulse width. Within the deadband, output state is neutral. The deadband value is configurable using the REV Hardware Client or through the CAN interface.
5V Supply Output Voltage (Vout)
V
5V Supply Output Current †
-
-
500
mA
Digital Input Voltage Range
0
-
5
V
Digital Input High Voltage
1.85
-
-
V
Digital Input Low Voltage
-
-
1.36
V
Analog Input Voltage Range
0
-
Vout
V
†
Available output current may be reduced when the SPARK Flex is powered only by USB and not main power.
Power Wire Gauge
12 AWG
Power Wire Length
450 mm (17.72in)
Control Wire Gauge
26 AWG
Control Wire Length
450 mm (17.72in)
Through Bore Diameter
16.5 mm (0.649 in)
Mounting Footprint Narrow Side Width
2 in
Mounting Footprint Rounded Side Diameter
60 mm
Mounting Holes
#10-32 on 2 in bolt circle
Mounting Hole Maximum Depth
0.25 in
Body Length (Not Docked)
28.2mm
Docking Hardware
M3 SHCS x 25mm
Weight (with Wires & Docking Screws)
130g (0.29lb)