GEAR IDLER ASSEMBLY COMPLETE.
Repeat the above steps until there are four completed Gear Idler Assemblies. Set aside for later.
15MM SPACER
1
SHAFT COLLAR
1
72 TOOTH PLASTIC GEAR
1
5MM X 75MM HEX SHAFT
1
Add an End Cap Bearing to the 75mm x 5mm Hex Shaft.
Slide a Shaft Collar onto the shaft. Tighten the set screw.
Note: the Shaft Collar should be flush with the bearing.
Slide a 15mm Spacer onto the shaft.
Slide an 72 Tooth Plastic Gear onto the shaft
Add an End Cap Bearing to the shaft.
Note: the smaller portion of the bearing faces away from the gear
