We're Updating our Documentation! For the most up-to-date information about the Pneumatic Hub and other ION Control System Devices please check out the following new documentation pages:
The REV Hardware Client has three tabs to manage different features of the Client. The Hardware Tab is where supported hardware devices are managed. The Downloads Tab allows for the downloading of supported device software for updating when offline. The About Tab has information on what devices are supported, updating the REV Hardware Client, and having issue reporting.
The Basic Tab is used to set the most common parameters for the Pneumatic Hub. You can also view and clear sticky faults here.
Sticky Fault - an indicator there was a fault that will stay until the fault has been cleared manually.
Using the REV Hardware Client, you can completely operate and test your pneumatic system without needing a roboRIO or software. Here are some useful applications that can help your team:
Testing your pneumatic system in a bench top setting
Testing the pneumatic system on your robot without the need for software support (e.g. allowing your build team to test the pneumatics while your programmers are busy).
Using pneumatics in your quick and early prototypes during the beginning of the build season
Using the telemetry tab on the Hardware Client, you can see if you have leaks in your systems or check how much pressure you lose during normal operation without needing to write extra software. (An analog pressure sensor is needed).
We're Updating our Documentation! For the most up-to-date information about the Pneumatic Hub and other ION Control System Devices please check out the following new documentation pages:
The REV Hardware Client is software designed to make managing REV devices easier for the end user. This Client automatically detects connected device(s), downloads the latest software for those device(s), allows for seamless updating of the device(s), and allows for device configuration and management.
For more information on the REV Hardware Client, including a full list of supported devices, see the User's Manual.
Operating System: Windows 10 (64-bit) or newer
Processor: 64-bit
Download the REV Hardware Client Installer above.
Run the Installer
Run the REV Hardware Client from the Windows Start Menu or a desktop shortcut
Startup the REV Hardware Client. Once the Pneumatic Hub is fully connected it will show up on the front page of the UI under the Hardware Tab. Select the Pneumatic Hub.
After selecting the Connected Hardware, the Update tab will pop up. Under Pneumatic Hub Firmware select Download.
Once the firmware has downloaded, select Update. (Your Hardware Client will say "Update" instead of "Re-install")
When the firmware update has completed a status message "Update Completed" will appear. The status for the Pneumatic Hub Firmware will also change to "Up-to-Date."
Latest REV Hardware Client - Version 1.5.3 |
---|