Assembly Instructions
Suggested Tools and Suggested Materials
Teams will need to cut and tap some pieces of structural tubing in order to build the 2023 REV ION FRC Starter Bot. The following sections detail the quantity and length needed for each type of extrusion.
Every piece of structural tubing needs to start with a hole 1/2in (or slightly less) from the end where the length measurement is taken FROM.
2x1 Light MAXTube with Grid Pattern:
1x 22-1/2in (Tower Bottom Crossbar)
2x 2-1/2in (Tower Riser)
3/4in Dead Axle Tube:
2x 26-3/4in (Tower Brace)
2x1 Light MAXTube with Grid Pattern:
1x 21-1/2in (Tower Bottom Crossbar)
2x 1-1/2in (Tower Riser)
3/4in Dead Axle Tube:
2x 26-7/8in (Tower Brace)
2x1 Light MAXTube:
1x 19-1/2in
1x 23-1/2in
2x1 MAXTube with MAX Pattern:
2x 13in
2x 9in
2x 23in (Stock Length)
2x 31in (Stock Length)
1x1 MAXTube:
2x 13-3/8in (one end must have a hole 1/2in from the edge of the tube)
1x 15in
1/2in Rounded Hex Shaft (Tap Both Ends):
1x 1-1/2in
1x 15in
1x 18-1/2in
1x 20-1/2in
1x 20-3/4in
1x 20-7/8in
1x 23-1/4in
1x 25-5/8in
MAXSpline Shaft:
1x 22in
3/4in Dead Axle Tube:
1x 23-3/8in
#25 Chain:
2x 8in (32 links)
2x 46in (184 links- plus or minus a few links for the turnbuckles)
2x 72in (288 links- plus or minus a few links for the turnbuckles)
Instructions on how to build the ION West Coast Drive are found here: 2023 REV ION FRC West Coast Drivetrain Build Guide You can also check out the CAD on OnShape here: West Coast Drivetrain