Getting Started with the REV Hardware Client

We're Updating our Documentation! For the most up-to-date information about the Pneumatic Hub and other ION Control System Devices please check out the following new documentation pages:

The REV Hardware Client is software designed to make managing REV devices easier for the end user. This Client automatically detects connected device(s), downloads the latest software for those device(s), allows for seamless updating of the device(s), and allows for device configuration and management.

For more information on the REV Hardware Client, including a full list of supported devices, see the User's Manual.

Latest REV Hardware Client - Version 1.5.3

System Requirements

  • Operating System: Windows 10 (64-bit) or newer

  • Processor: 64-bit

Installation Instructions

  • Download the REV Hardware Client Installer above.

  • Run the Installer

  • Run the REV Hardware Client from the Windows Start Menu or a desktop shortcut

Updating your Pneumatic Hub

Startup the REV Hardware Client. Once the Pneumatic Hub is fully connected it will show up on the front page of the UI under the Hardware Tab. Select the Pneumatic Hub.

After selecting the Connected Hardware, the Update tab will pop up. Under Pneumatic Hub Firmware select Download.

Once the firmware has downloaded, select Update. (Your Hardware Client will say "Update" instead of "Re-install")

When the firmware update has completed a status message "Update Completed" will appear. The status for the Pneumatic Hub Firmware will also change to "Up-to-Date."

Last updated