LogoLogo
REVLib Docs
  • REV ION Control System
  • Quick Links
  • Frequently Asked Questions
  • Power Distribution Hub
    • Power Distribution Hub Overview
    • Power Distribution Hub Specifications
    • Getting Started with the Power Distribution Hub
      • Wiring the Power Distribution Hub
    • Power Distribution Hub Status LED Patterns
    • Power Distribution Hub Troubleshooting
    • Power Distribution Hub Firmware Changelog
  • Pneumatic Hub
    • Pneumatic Hub Overview
    • Pneumatic Hub Specifications
    • Getting Started with the Pneumatic Hub
      • Wiring the Pneumatic Hub
    • Pneumatic Hub Status LED Patterns
    • Pneumatic Hub Troubleshooting
    • Pneumatic Hub Firmware Changelog
  • Radio Power Module
    • Radio Power Module Overview
    • Radio Power Module Specifications
    • Getting Started with the Radio Power Module
    • RPM Compatibility with the new FRC Radio
  • Mini Power Module
    • Mini Power Module Overview
    • Mini Power Module Specifications
    • Mini Power Module Status LED Patterns
  • Sensors
    • 2m Distance Sensor
    • Color Sensor V3
    • Magnetic Limit Switch
    • Potentiometer
    • Through Bore Encoder
    • Touch Sensor
  • Accessories
    • Blinkin LED Driver
    • Digital LED Indicator
    • Servo Power Module
  • Software Resources
    • REV Hardware Client Documentation
    • REVLib
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Sensors

Potentiometer

PreviousMagnetic Limit SwitchNextThrough Bore Encoder

Last updated 6 months ago

Was this helpful?

The REV Potentiometer () converts the angular position of a shaft into an analog voltage signal. A potentiometer acts as an adjustable resistor, fluctuating resistance as the shaft is turned. As the wiper (the knob) moves up and down along the coils of the resistor and the resistance and voltage output change proportionally at each new position.‌

Check out our documentation of the .

REV-31-1155
Potentiometer