NEO 2.0
NEO 2.0 Overview
Features
High-performance brushless DC motor designed for competitive robotics
Compatible with all SPARK brushless motor controllers.
Fully integrated hall-effect encoder for closed-loop control
Adopts the SPARK FLEX mounting pattern for direct compatibility with MAXPlanetary and the broader REV ecosystem, aligning flats for a low-profile fit
Drop-in replacement for CIM-style motors
Front and rear ball bearings
High temperature neodymium magnets
Motor temperature sensor
Connectorized motor sensor output for use with the NEO 2.0 Sensor Cable
Diametrically magnetized magnet on the rotor-end of the shaft to support magnetic encoder.
New to NEO 2.0
15T spline shaft for secure power transfer without the need for keys or keyways
Detachable encoder cable for easy replacement and serviceability.
Slimmed 2-inch width profile with exposed outrunner design, allowing mounting within the silhouette of common 2in structural tubing like MAXTube.
Repositioned sensor board for better thermal reliability.
Wiring Connections
Follow the guide at Wiring the Spark Max, and don't forget to connect your sensor wire; the motor will not spin without it!
CAUTION: Improperly wiring the connectors can cause severe motor damage and is not covered by the warranty. DO NOT connect the motor directly to the battery.
Motor Specifications
Nominal Operating Voltage
12 V
Motor Kv
473 Kv
Free Speed`
5676 RPM
Free Running Current
1.8 A
Stall Current
150 A
Stall Torque
3.75 Nm
Peak Output Power
540 W
Mechanical Specifications
Output Shaft Diameter
15T Spline
Output Shaft Length
31.5mm (1.24in)
Output Pilot
19.05mm (0.75in)
Body Length
48mm (1.89in)
Body Diameter - Maximum
60mm (2.36in)
Body Diameter - Minimum
50.8mm (2in)
Mounting Face minimum width
50.8mm (2in)
Mounting Holes
#10-32 tapped
Mounting Hole Depth
9.5mm (0.375in)
Shield Mounting Screws
M3
Shield Mounting Screw max depth
2mm
Weight
364g (0.8lb)
Phase Wire Length
150mm (5.91in)
Phase Wire Gauge
12AWG
Last updated
Was this helpful?